Contact
The face is what a wearer and a packing line both touch. Hand, noise of the cloth, and surface abrasion resistance belong with the face construction, not with a membrane slogan. If two sympatex fabric ideas share a similar mass, still compare weave construction or knit, yarn count, warp and weft, and any face finish on cuttings. Fiber composition sits on its own line. GSM in g/m² does not replace it. Denier is grams per 9,000 metres and dtex is grams per 10,000 metres. Shade approval under an agreed light is not a colorfastness result, not a lab dip approval, and not a durability result. A shade band is a bulk visual limit, not a pilling score.
Care sits next to contact. A shell that will be home-washed, professionally cleaned, or only wiped needs that sentence in the brief, because a finish that feels right on day one can be the wrong reference after the care cycle you actually use. Do not borrow a care symbol from a finished garment and paste it onto a roll specification.
Exposure
Rain, wind-driven wet, and prolonged damp are liquid-water questions. Comfort during effort is often a water vapor transmission question. Air permeability through a face fabric is a third question. These should not be collapsed into one outdoor adjective. For a membrane comparison, ask which specimen faced the weather: film alone, two-layer laminate, three-layer laminate, or a seam. Hydrostatic head belongs with pressure, duration, and which side faced the water. Gradient, temperature, and conditioning belong in the vapor note. When a sheet cites the standard textile atmosphere, check 20 °C and 65 % relative humidity and printed tolerances of ± 2 °C and ± 4 % RH. Coating and lamination are opposing build choices here, not a ranking: a coated substrate is reviewed for coating add-on and hand, while a laminated construction is reviewed for film continuity, bond, and peel on the same specimen state.
Flex and pack add fatigue that a flat coupon may never see. If the garment will be stuffed daily, say so, and ask whether any abrasion resistance or hydrostatic discussion used a flexed specimen or a pristine one. Stretch recovery and seam slippage answer different fatigue questions. This page does not supply pass-fail numbers for those conditions. Worked reading, not a client trial: the background is a shell that is packed wet and home-washed; the process is to split rain, vapor, and face abrasion into three method rows and to note usable width before cutting; the result is a brief that still has blank cells where no report was attached. Tear strength and tensile strength stay blank unless a method is named.
Processing
Cutting needs a usable width and a note on dimensional stability under the heat or pressure of the table you use. Joining needs the seam type you intend: sewn and taped, welded, or another method. A membrane that looks continuous in a panel can still be the weak line at the join, so the panel report and the seam report should not share a single unchecked box. Batch traceability and roll inspection belong with the goods you later compare to the cutting, not with the first sketch.
Bond and backing matter when the face is laminated rather than merely finished. Ask whether the backing is there for hand, for protection of the film, or for a process aid, and whether that backing survives the assembly step. Stock and custom development split the same way as the build choice: stock asks for the dated batch you can actually see, and custom development asks for sample, trial, and bulk gates. Quantity and destination can be added once the construction is clear. They do not replace the exposure notes above, and they do not create a certificate or a plant figure this page does not have.